INSTA-CURE +Gap Filling Cyanoacrylate 1oz

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the
adhesive must bridge gaps. Normally, the thicker CA is applied to one
surface and then the parts are held
tightly together for about 5 to 15 seconds. For
large surface areas, including those with close fitting joints such as
laminations, INSTA-CURE+ ™ should also be used. To prevent premature
curing, don’t spread the glue into a thin film. Lay down a serpentine bead
with about 1″ separations on one
surface, then assemble the parts, letting the
pressure spread the CA out.