Mark Fit

Mark Fit is a special solvent designed to soften your model decalswhich will allow you to apply them onto difficult to apply areas suchas bumpy and curved surfaces, providing an improved finish to yourscale model. The 40ml bottle contains a convenient brush for easyapplication.

• Apply Mark Fit solvent to area where decal is to bepositioned.
• Place decal onto the area.
• Slide decal into correct position by a wet finger.
• Use a soft cloth or cotton swab to remove excess water andany air bubbles.
• Apply Mark Fit over the decal again, and then use a softcloth or cotton swab to conform it to the model’s surface.
• Do not touch until decal dries completely.